Philips 43PP9202, 50PP 9202, 60PP9202 manual Setting the TIMER’S Activate Control

Using the Onscreen Submenus: Features

SETTING THE TIMER’S ACTIVATE CONTROL

After you have set the TIME, START TIME, STOP TIME, and CHANNEL, you

must activate the Timer for it to operate. Your options are to set the Timer to work ONCE or DAILY. Set ACTIVATE to OFF if you don’t want to use the Timer.

BEGIN

PICTURE	TIMER	FEATURES
SOUND	AutoLock			TIME
			TIMER
FEATURES	PIP
			AutoLock	START TIME
INSTALL	CLOSED CAP
			PIP	STOP TIME
	FORMAT
			CLOSED CAP	CHANNEL
			FORMAT	ACTIVATE

1 Press the MENU/SELECT button on the remote control to show the onscreen menu.

	Press the CURSOR RING DOWN				POWER		FEATURES
							TIMER
2 twice to highlight FEATURES.							TIME	8:06 PM
							START TIME
3	Press the CURSOR RING RIGHT					3,4,	STOP TIME
	to enter the FEATURES submenu.		TV	VCR	ACTIVE ACC		CHANNEL
							ACTIVATE
	Press the CURSOR RING RIGHT		SWAP	PIP CH	CONTROL FREEZE	5
		6	DN	UP
	again. Then press the CURSOR RING		SOUND
4 DOWN repeatedly until the ACTI-
	VATE control is highlighted.		STATUS/		MENU/		FEATURES
			EXIT		SELECT		TIMER
	Press the CURSOR RING RIGHT
							TIME
	to cycle through the options and make			MUTE			START TIME
5 your selection. The options are			VOL		2	1	STOP TIME
	ONCE, DAILY, or OFF.						CHANNEL	ONCE
							ACTIVATE

6 Press the STATUS/EXIT button to exit the menu.

HELPFUL HINTS

•Changing the channel or adjusting the volume during the last minute of a Timer setting will cancel the shutting off of the TV.

•Thirty seconds before the set changes to the channel you set (see page 40), an announcement appears on screen.

1	2	3
4	5	6
7	8	9	ACTIVATE
TV/VCR	0
A/CH		SURF
			ACTIVATE
	POSITION	PIP

OR

DAILY

OR

OFF

CHANGING TO CHANNEL 5 IN 29 SEC

41