AW 7150/AW 7250/00. page 7
Recording
RECORDING
Copyright:
Recording is permissible insofar as copyright or other rights of third parties are not infringed.
Safeguarding a cassette against erasure: Accidental erasure can be prevented by
breaking the small tab in the top corner of the | |
back of the cassette. |
|
This protection can be reversed |
|
with a piece of adhesive tape | 1 |
placed over the same corner. |
|
Winding the tape
•Press F.FWD 5 to fast forward the tape.
•Press REW 6 to fast rewind the tape.
•Press STOP 9 to stop fast forward or fast- rewind, or before the end of the tape.
RECORDING (on deck 2 only)
•Press EJECT / to open the cassette holder.
•Insert the cassette into deck 2. 
For recording you must use a NORMAL cassette (IEC I) on which the tabs have not been
broken.
At the very beginning of the tape, no recording will take place during the first seven seconds when the leader tape passes the recorder heads.
•When monitoring during recording, adjust the sound with the controls VOLUME and TONE. These controls do not affect the recording.
•To stop, Press STOP 9.
RECORDING FROM THE RADIO
• Set the TAPE/RADIO selector to RADIO.
Mono recording from the built-in microphone
•Set the TAPE/RADIO selector to TAPE
•Set the VOLUME control to the minimum volume level (during microphone recordings, monitoring is not possible)
STARTING AND STOPPING THE
RECORDING
•To start recording, press RECORD 0 and PLAY 1 is then pressed at the same time.
–When the end of the tape is reached, the recorder buttons are released.
•To interrupt recording, press PAUSE ;.
•To continue recording, press PAUSE ; again.
•Press STOP 9 if you want to stop the recording before the end of the tape. On pressing again, the cassette holder will open.
•The set is switched off if the TAPE/RADIO selector is in position TAPE and no buttons are pressed.
DUBBING – Copying from deck 1 to 2
When dubbing, it is recommended to use fresh batteries or to connect the set to the mains supply.
• Set the TAPE/RADIO selector to:
–DUBBING - for normal speed copying
–
Do not switch this selector during dubbing.
•Press both EJECT / buttons and insert a recorded cassette into deck 1 and a cassette which is suited for recording into deck 2.
•Press PAUSE ; followed by RECORD 0 on deck 2.
•To start dubbing, press PLAY 1 on deck 1.
•Press PAUSE ; on deck 2 if you wish to omit undesired passages and the playback in deck 1 will continue. To restart dubbing, press PAUSE ; again.
•By pressing PAUSE ; in deck 1 during dubbing, a blank part will be recorded in deck 2.
•To stop dubbing, press both STOP buttons 9. The set is then switched off.
English
7
