Safety & Maintenance (See 0)
Safety information | CD player and CD handling |
•Place the set on a hard, flat and stable surface so that the system does not tilt.
•Where the MAINS plug or an appliance cou- pler is used as the disconnect device, the dis- connet device shall remain readily operable.
•Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
•The apparatus shall not be exposed to dripping or splashing.
•Adequate ventilation with a minimum gap of 15 cm between the ventilation holes and sur- rounding surfaces is necessary to prevent heat
•The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers,
•No objects filled with liquids, such as vases, shall be placed on the apparatus.
•No naked flame sources, such as lighted can- dles, should be placed on the apparatus.
•The mechanical parts of the set contain
•To clean the set, use a dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated into three materials: cardboard, polystyrene and plastic.
Your set consists of materials which can be recycled if disassem- bled by a specialized company. Please observe the local regula- tions regarding the disposal of packaging, dead batteries and old equipment.
•If the CD player cannot read CDs correctly, use a cleaning CD to clean the lens before taking the set to repair.
•The lens of the CD player should never be touched!
•Sudden changes in the surrounding temperature can cause condensation on the lens of your CD player. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.
•Always close the CD door to avoid dust on the lens.
•To clean the CD, wipe in a straight line from the center towards the edge using a soft,
•Never write on a CD or attach any stickers to it.
Cassette recorder
•To ensure a good recording and playback of the tape deck, clean parts A,B and C shown in the diagram below, after approx. 50 hours of operation, or on average once a month. Use a cotton bud slightly mois- tened with alcohol or a special head clean- ing fluid to clean the deck.
•Open the cassette holder by pressing 9 /.
•Press 1 and clean the rubber pressure rollers C.
•Press ; and clean the magnetic heads A and also the capstans B.
•After cleaning, press 9 /.
•Cleaning of the heads can also be done by playing a cleaning cassette through once.
