Power Supply
Power Supply
Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.
Batteries
Main set (See 1)
•Insert 6 batteries, type
Remote control Important!
•Before using the remote control, remove the insulation plastic tab as shown
in figure !.
•If the remote control does not function correctly or the operating range is reduced, replace the battery with a new (CR2025) type battery
1Press and hold the latch (A) in the direction as shown in figure !.
2Simultaneously, pull the battery tray (B) out.
3Replace a new battery, and fully insert the battery tray back to the original position.
•Incorrect use of batteries can cause elec- trolyte leakage and will corrode the compart- ment or cause the batteries to burst:
•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
•When inserting new batteries, do not try to mix old batteries with the new ones.
•Remove the batteries if the set is not to be used for a long time.
Batteries contain chemical substances, so they should be disposed of properly.
Using AC power
1Check if the power/mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.
2Connect the power cord to the
AC~ MAINS inlet and the wall socket.The set is now ready for use.
3To switch the set off completely, withdraw the power cord from the wall socket.
4Install the unit near the AC outlet and where the AC power plug can be easily reached.
•Disconnect the power cord from the wall socket to protect your set during heavy thun- derstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit.
The type plate is located on the bottom of the set.
Auto power saving
•When the source selector is adjusted to DISC/USB and the set is in the PAUSE position for 5 minutes, the set will be auto switched to the stop position to save power.
Helpful hints:
–To avoid unnecessary energy consumption, always adjust the source selector to OFF after using the set.
CAUTION
-Visible and invisible laser radiation. If the cover is open, do not look at the beam.
-High voltage! Do not open.You run the risk of getting an electric shock.The machine does not con- tain any
-Modification of the product could result in hazardous radiation of EMC or other unsafe operation.
-Use of controls or adjustments or performance of precedures other than herein may result in unsafe operation.
