Basic Function/ Radio | Cassette Recorder |
Basic functions
Switching on/off the set
1To switch on, adjust the source selector to DISC/USB, FM or TAPE as desired.
2To switch off, adjust the source selector to OFF.
Adjusting sound
Adjust the sound with the VOLUME and DBB controls.
Radio reception
1Push the source selector to FM
2Turn TUNING to tune in a radio station.
3To switch off the radio, adjust the source selector to OFF.
Helpful hints:
To improve reception
•For FM, extend, incline and turn the telescopic antenna. Reduce its length if the signal is too strong.
Playing a tape
1Set the source selector to TAPE.
2Press 9 / to open the cassette holder.
3Insert a recorded cassette.
4Press 1 and playback will start.
5Adjust the sound using the VOLUME and DBB controls.
6For brief interruptions, press ;. Press ; again to resume playback.
7By pressing 5 or 6, fast winding of the tape is possible in both directions.
8To stop playback, press 9 /
➜The keys are automatically released at the end of the tape.
9Set the source selector to OFF position (with the cassette keys released) to switch off the set.
Note:
–During playback, the keys are automatically released at the end of a tape and the set is switched off (unless PAUSE mode ; has been activated.)
–During fast forwarding/rewinding, the keys will not be released at the end of a tape.To switch off the set, make sure the cassette keys are also released.
Cassette recording
General information on cassette recording
•Recording is permissible insofar as copyright or other rights of third parties are not infringed.
•This deck is not suitable for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. For recording you should use NORMAL type cassettes (IEC I) on which the tabs have not been broken.
•Check and tighten slack tape before use with a pencil to avoid jamming the deck mechanism.
•The recording level is set automatically.
