User Manual BDL4631V/00
17
BDL4631V
can be installed in port rait position, under th e following condition s:
Caution:
Portrait mode is
ef
fective only when wall-m ounted or ceiling-mou nted.
The
feet
can not be used f or the monitor in portr ait position.
Placing the monitor in p ortrait position, will shorten the
average
life of the
LCD
backlight.
Operational
Envir
onment
(T
emperatur
e)
shall
be limited,
as
shown below:
Operational
Envir
onment
Te
mperatur
e
5
-
35 °C
/
41
-
95
°F
Humidity
20
-
80
%
(without condensation)
Please
orientate the monitor in the direction shown as the right figure:
Do not place monitor in landscape in
any
other
manner
.
How to set-up
1.
Remove
the
feet if t hey are atta ched.
2.
The
“ ”
logo should be on the
RIGHT
side when facing the m onitor.
How to Remov e the Logo for lan dscape mode?
1. Prepare a piece of paper with a cut ting area of logo as a protector to
prevent the front bezel from scratching.
2. Using an knife, carefully remove the logo sticker with the paper placing
beneath.
3. Tear off the logo sticker.
How to Use th e Logo Guider for P ortrait Mode?
1. Before applying, make sure the guider is well shaped. The "PHILIPS"
sticker attached on the end of it could be folded back as fi gure a.
2. Turn back the logo end of the guider and remove the sticky tape of the
logo.
3. Slide the logo gui der along the short side of the front bezel as figure c &
then re-turn the logo end of the guider back t o the right side.
4. With your left hand fixing th e guider, scrunch the logo by your r ight hand
to make it stuck firmly on the front bezel.
5. Remove the guider and leave the logo over the front bezel.
Counterclockwise Clockwise