57
EN
Your receiver has beenmanufactured to meet the appropriate safety standards, but the instructions below must be
followed to operate it safely.These instructions must be kept forfuture reference.
- Before connecting the receiver to the mains,check that the mains supply voltage corresponds to the voltage printed on the rear
of the receiver.If the mains voltage is different, consult your dealer.
- The receiver does not contain anyuser-serviceable parts. Do not attempt to open it.All maintenance work must be carried out
by qualified services centres.
- If you disconnect the receiver from the mains,make sure to unplug it from the wall socket and not just from the AC socket at
the back of the unit.Children could seriously injure themselves, as the free end of the cable is still live.
- It is recommended to unplug the receiver from the mains during lightning storms.
- If the power cord is damaged,it must be replaced. Always refer to qualified services centres.
- To prevent fire or shock hazard,do not expose the receiver to rain or moisture.
- The receiver should be placed on a firm surface,and the ventilation openings must not be covered with items,such as
newspapers,table clothes, curtains, etc.
- Do not install the receiver near heat sources such as radiators,stoves or other apparatus that produce heat. Protect it from
direct sunlight.
- When installing the receiver, ensure there is a gap of approximately 2 cm around the receiver to enable air to circulate freely and
prevent overheating.
- Leave accessible the mains connector at the back of the unit in case emergency shutdown is required.
- Do not place any combustible objects on the receiver (candles,etc.).
- No objects filled with liquids,such as vases, should be placed on the unit.The receiver shall not be exposed to dripping or
splashing.Should this happen, disconnect your receiver from the mains and consult your dealer.
- Make sure that children do not place any foreign objects in any of the openings.
- For cleaning,use a soft, damp (not wet) cloth. Never use any abrasive cloth and aerosol cleaners.
Your receiver, as any electronic equipment,consumes power.In order to reduce power consumption, please switch your
receiver to “Low Power” whenever you are not using it. For maximum energy saving we recommend you switch off the
receiver by unplugging it from the mains if you are notusing it for a long time, e.g. during holidays.
3 Safety instructions