Philips DFR9000 manual Installation, General remarks, Connecting to your TV, SCART/RGBS connection

14ENGLISH

4. Installation

4.1 General remarks

–Most input sockets of your DFR9000 are assigned for connection to a specific device.

In the next chapters we will therefore only describe how to connect these specific devices to your DFR9000. If you wish to connect other devices, you first reassign the sockets for connection to these devices.This can be done in the system menu.

For this see '6.7 Reassigning input sockets' and '10.7 A/V Input menu'. Connections can then be made as described below. Please refer to the chapter 'Functional overview' for an overview of connectors and the devices they are assigned to.

–The numbers between brackets refer to the numbers in the illustrations on page 3.

–The arrows in the illustrations indicate the direction of the signal.

4.2 Connecting to your TV

SCART/RGBS connection

TV

SCART INPUT

•

•

•

•

•

CD IN CD-R IN AUX IN

Make sure the receiver is switched off and unplugged from the wall outlet before making any connections.

Connect the Scart control (2.5 mm jack) of the 6-cinch + Scart control to Scart cable supplied to the SCART CONTROL connector (22) of your DFR9000.

>When your DFR9000 is reactivated after being switched off, Scart control switches your Scart-enabled TV to the correct input source immediately.

Connect the red, green, blue and yellow plugs of the cable to the corresponding VIDEO OUT connectors (22) of your DFR9000.

Connect the red and white audio plugs of the cable to the corresponding LINE OUT connectors (22) of your DFR9000.

Connect the Scart connector at the other end of the cable to the Scart input connector of your TV.