Philips DMR-EH55 operating instructions Connecting a television and VCR, Connection

BConnecting a television and VCR

To the aerial

Television’s rear panel

AUDIO IN VIDEO IN

VHF/UHFR L

RF IN

Red White Yellow

1	4
		RF coaxial cable	5
		(included)
	Aerial cable
		Audio/Video cable
		(included)

[For\Saudi\Arabia[ BE SURE TO
READ THE	To household mains socket
CAUTION FOR
	[For]Australia]and]N.Z.]
THE AC MAINS
LEAD ON PAGE	(AC 220 to 240 V, 50 Hz)
2 BEFORE	[For]Asia]and]Middle]East]
CONNECTION.	(AC 220 to 240 V, 50/60 Hz)
Other	6
connections

(➡ 16)

AC mains lead (included)

Connect only after all other connections are complete.

[For]Middle]East]

≥Use the AC mains lead that matches the socket for the area you live in.

STEP 1 Connection

RF		RF		Red White Yellow
OUT		IN
			AV1 (TV)	OUT
Y	PB	PR
				AV4 IN
COMPONENT VIDEO OUT			AV2 (DECODER/EXT)	R-AUDIO-L VIDEO	S VIDEO
				Red White Yellow
	2			3
RF coaxial cable
(included)			Audio/Video cable

Red White Yellow

VHF/UHF	RF OUT	R	L
RF IN		AUDIO OUT VIDEO OUT

VCR’s rear panel

OPTICAL AC IN

DIGITAL AUDIO OUT (PCM/BITSTREAM)

This unit’s rear panel

Cooling fan

Connect the unit directly to the television

If you connect the unit through an AV selector or video cassette recorder to the television, video signal will be affected by copyright protection systems and the picture may not be shown correctly.

Television

VCR

This unit

≥When connecting to a television with a built-in VCR

Connect to the input terminals on the television side if there are both television and VCR input terminals.

Connecting to a television with 21-pin Scart terminal

You can also connect with the AV1 terminal on this unit using the 21-pin Scart cable.

If your television is equipped with RGB input capability, by connecting with a fully wired 21-pin Scart cable you can see video using RGB output on this unit.

[Required]setting]

“AV1 Output” in the Setup menu (➡ 61)

Connecting to a VCR with 21-pin Scart terminal

You can also connect with the AV2 terminal on this unit using the 21-pin Scart cable.

[Required]setting]

“AV2 Input” in the Setup menu (➡ 61)

RQT8361

15