Connecting an Antenna or Cable TV

aAntenna:

Disconnect the antenna from the rear of the TV and identify the antenna cable. If it is a round 75 ohm coaxial cable connect it directly to the jack marked ANT.IN on your Recorder. If your antenna cable is flat connect it to a 300-ohm to 75-ohm antenna adaptor (not supplied) and slip the adaptor over the ANT.IN jack. Don’t attempt to screw it into to the Recorder.

bCable TV:

If your cable connection has no converter or descrambler, unscrew the cable from your TV and attach it to the ANT.IN jack on the Recorder. If a con- verter is required connect a coaxial cable from the wall jack to the IN connector on the converter, and a coaxial cable from the OUT connector on the convert- er to the ANT.IN on your Recorder. This cable hookup permits both TV and Recorder operation.

a

Antenna

Antenna

 

OR OR

Rear of Recorder

b

To view or record a CATV channel

1.Tune the TV to the Recorder output channel (CH 3 or 4).

2.Set the Recorder channel selector to the cable output channel. (Example: CH3)

3.Select a channel using the cable converter.

Notes:

With this connection, you cannot record one program while viewing another.

If you are using a cable box to tune channels, it is not necessary to do Auto Channel Set.

Connections to your TV

Make one of the following connections, depending on the capabilities of your TV.

Hookup and Settings

13

Page 13
Image 13
Philips DVDR3320V user manual Connecting an Antenna or Cable TV, Connections to your TV, To view or record a Catv channel