Philips DVDR 70/021, DVDR 70/001 manual Connecting with an S, AMy screen is empty

Virgin mode

Menu Language

English

Español

Français

Italiano

Deutsch

Press OK to continue

aMy screen is empty.
b Many TV sets are switched by the DVD recorder to the programme
	number for the scart socket by way of a control signal sent through the
	scart cable.
b If the TV set does not automatically switch to the scart socket programme
	number, manually change to the corresponding programme number on your			ENGLISH
	TV set (see your TV's operating instructions).
b Check that the scart cable is connected from the TV set to the		EXT 1
	TO TV-I/Osocket on the DVD recorder. The EXT 2 AUX-I/Osocket is		Problem
	intended only for additional devices.

Then, read the paragraph on 'Initial installation' in 'Installing your DVD recorder'.

Connecting with an S

This connecting cable, also known as the SVHS cable, is used to transmit the brightness signal (Y signal) and colour signal (C signal) separately. This mini DIN socket/plug is also called a Hosiden socket/plug.

Have the following cables ready:

an aerial cable (1, supplied), a mains cable (2, supplied), an S-Video(SVHS) cable (3), an audio cable (4, red/white plug).

1Remove the aerial cable plug from your TV set. Insert it into the ANTENNA IN socket at the back of the DVD recorder.

2Insert one end of the supplied aerial cable into the TV OUT socket at the back of the DVD recorder and the other end into the aerial input socket at the back of the TV set.

3Insert one end of an S-Video(SVHS) cable into the OUT S-VIDEO (Y/C) socket at the back of the DVD recorder and the other end into the S-Video (SVHS) input socket on the TV set (usually labelled 'S-Video in' or 'SVHS in'. See TV operating instructions).

Connecting the DVD recorder 15