Yamaha RX-V559 owner manual Connecting the power cable, Ac Outlets Switched

CONNECTIONS

Connecting the power cable

Once all connections are complete, plug the power cable into the AC wall outlet.

(U.S.A. model)

AC OUTLETS

To the AC wall outlet

PREPARATION

■VOLTAGE SELECTOR

(Asia and General models only)

CAUTION

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.

Rotate the VOLTAGE SELECTOR clockwise or counterclockwise to the correct position using a straight slot screwdriver.

Voltages are as follows:

Asia model	220/230–240 V AC, 50/60 Hz
General model	110/120/220/230–240 V AC, 50/60 Hz

■AC OUTLET(S) (SWITCHED)

U.K. and Australia models	..................................... 1 outlet
Korea model	None
Other models	2 outlets

Use these outlet(s) to supply power to any connected components. Connect the power cable of your other components to these outlet(s). Power to these outlet(s) is supplied when the main zone or Zone 2 is turned on. However, power to these outlet(s) is cut off when the main zone and Zone 2 are turned off or when MASTER ON/ OFF on the front panel is pressed and released outward to the OFF position. For information on the maximum power or the total power consumption of the components that can be connected to these outlet(s), see “SPECIFICATIONS” on page 109.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is in the standby mode.

VOLTAGE

SELECTOR

230-

240V

Voltage indication

However, the stored data will be lost in case the power cable is disconnected from the AC wall outlet or if the power supply is cut off for more than one week.

25