Warning
1.General
.All ICs and many other semiconductors are susceptible to electrostatic discharges (ESD). Careless handing during repair can reduce life drastically. Make sure that, during repair, you are at the same potential as the mass of the set by a wristband with resistance. Keep components and tools at this same potential. Available ESD protection equipment:
1)Complete kit ESD3 (small tablemat, wristband, connection box, extension cable and earth cable) 4822 310 10671.
2)Wristband tester 4822 344 13999.
.Be careful during measurements in the live voltage section. The primary side of the power supply , including the heat sink, carries live mains voltage when you connect the player to the mains (even when the player is “off”!). It is possible to touch copper tracks and/or components in this unshielded primary area, when you service the player. Service personnel must take precautions to prevent touching this area or components in this area. A “lighting stroke” and a
side of the power supply.
.Never replace modules, or components, while the unit is “on”.
2. Laser
.The use of optical instruments with this product, will increase eye hazard.
. Only qualified service personnel may remove the cover or attempt to service this device, due to possible eye injury.
. Repair handing should take place as much as possible with a disc loaded inside the player.
.Text below is placed inside the unit, on the laser cover shield:
CAUTION: VISIBLE AND INVISIBLE LASER
RADIATION WHEN OPEN, AVOID EXPOSURE
TO BEAM.
Notes: Manufactured under licence from Dolby Laboratories. The
