PRV-9000 Operating Instructions

To confirm that all timer entries will fit on the loaded disc, follow the steps below.

1.Use the joystick to highlight Confirm on the Timer Program screen.

2.Press ENTER to calculate the disc space needed for the recordings.

3.Verify that Rec OK appears next to each timer recording entry.

If the timer program is too long for the disc then Time Over appears next to the entry. However, the timer entry records as much of the program as possible until the disc is full.

With a daily or weekly program, the Rec OK message appears next to the last entry that can fit on the loaded disc (up to a maximum of one month in advance).

If Optimize Disc is active (ON) during a timer recording, the PRV-9000 adjusts the recording quality to fit as much of the sequence as possible on to the disc. However, if the timer entry is still too long for the available disc space, the Time Over message appears.

6.2.2Program With VCR Plus+ When the Power is OFF

The recorder can be in Standby mode when entering VCR Plus+ program codes. The following guidelines apply to recording with VCR Plus+ codes.

Guide channels must be programmed in to the recorder before using a VCR Plus+ codes.

The recording mode is locked when using VCR Plus+ program codes.

VCR Plus+ codes are valid with Once (single-session) recordings only. Daily and Weekly timer recordings are unavailable with this feature.

To program in VCR Plus+ codes while the recorder is powered OFF (Standby mode), follow the directions below.

1.Press the PLUSCODE button.

The front panel displays the current recording mode and prompts the user to enter a code.

2.Input the number using the number pad on the remote control. To erase the last digit entered, press CLEAR.

SP PlusCode#

(becomes)

SP 29324

81

Page 89
Image 89
Pioneer PRV-9000 operating instructions SP PlusCode#, Program With VCR Plus+ When the Power is OFF