PRV-9000 Operating Instructions

seconds behind the actual time so adjust the timer program for this slippage. When the signal ceases, the recorder stops recording.

Follow the directions below to record from a satellite tuner or other device.

1.Set the timer on the satellite tuner.

Refer to the device’s operating instructions for assistance.

2.Switch the satellite tuner’s power to OFF (or in to Standby).

3.Load a recordable disc in to the recorder.

4.Verify Audio In options are at the desired settings.

For more information, refer to Chapter 9:INITIAL SETTINGS MENU, section 9.1.5 Audio In Settings.

5.Press REC MODE to set the recording mode.

Refer to Chapter 4: GETTING STARTED, section 4.10 Initializing Recording Modes.

6.Press and hold FUNCTION on the recorder’s front panel for approximately three seconds.

The recorder returns to Standby and the AUTO REC indicator lights. The recorder turns ON then OFF in sync with the satellite tuner.

The auto-start function is unavailable in the following situations:

recorder is already recording a program

loaded disc is full or other than recordable media

loaded disc is protected

loaded disc already contains the maximum number of titles (99)

another timer recording program is already in progress

timer program supercedes a auto-start program

auto-start automatically launches after the timer program is complete

6.3.4Record From the DV Output Port

To record from a non-copy-protected DVD disc to a camcorder, use the DV IN/OUT port on the recorder’s front panel. Follow the directions below to record from a disc to a camcorder.

1.Connect the camcorder to the DV IN/OUT port.

2.Load the source disc.

3.Scan to the segment to be recorded.

86

Page 94
Image 94
Pioneer PRV-9000 Refer to the device’s operating instructions for assistance, Record From the DV Output Port