| CD |
|
|
English | Disc Change |
You can change the outer two discs | |
| while the third inner disc is stopped or |
| is playing. |
1Press DISC CHANGE.
™ The CD carousel tray slides out.
2Replace the discs in the left and right disc trays.
•If you wish to change the inner disc during playback, press DISC CHANGE again.
™"DISC CHANGE" will be displayed.
™The CD will stop playing.
™The CD carousel tray will close to retrieve the inner CD then open again with the inner CD accessible.
3Press OPEN•CLOSE to close the CD carousel tray.
Selecting a desired track
Selecting a desired track when playback is stopped
1Press í or ë (or Digit
2Press É(PLAY) to start playback.
™The selected track number and elapsed playing time appear on the display.
34
Selecting a desired track during playback
•Press í or ë (or Digit
™The selected track number and elapsed playing time appear on the display.
•If you press í once it will skip to the beginning of the current track and play the track again.
Note:
–Pressingí during shuffling can only skip to the beginning of the current track.
Searching for a particular passage during playback
•Press and hold à or á until the desired passage is located.
™ The volume will be reduced.
•Play returns to normal when à or á is released.
Programming Tracks
Programming tracks of a loaded CD is possible when playback is stopped.The display will indicate the total tracks stored in the program. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show "PROGRAM FULL".
1Load the desired discs in the disc trays.
2Press PROG to start programming. ™ The PROG starts flashing.
3Press the CD (CD 1•2•3) or
CD 1/2/3 button to select the disc.
4Press í or ë (or Digit
5Press PROG to store the track.
•Repeat steps 3 to 5 to store other discs and tracks.
6Press Ç once to end programming.
™The total number of tracks programmed and total playing time appear on the display.
Notes:
–If the total playing time is more than
"99:59" or if one of the programmed tracks has a number greater than 30, then
–If the system is reading the disc, programming is not possible, "READING" will be displayed and followed by "DISC X" "X" is the current read disc number.
–During programming, if no button is pressed within 20 seconds, the system will exit program mode automatically.
Reviewing the program
Reviewing of the program is possible only when playback is stopped.
1Press í or ë repeatedly to review the programmed tracks.
2Press Ç once to exit review mode.
Playing the program
1PressÉ(PLAY) to start program playback.
™"PLAY PROGRAM" will be displayed.
™The track number and elapsed
playing time of the current track will appear on the display.
•If you press REPEAT during program playback, the current track or all programmed tracks will be played repeatedly.
™"TRACK" or "PROGRAM" will be displayed.
™The REPEAT and PROG appear on the display.
2Press Ç to stop program playback.
pg | 34 | 7/13/00, 11:51 AM | 3139 116 19774 |
