Philips HD7762 Before first use, Using the appliance, Setting the clock, Flushing the appliance

4 Before first use

4.1 Setting the clock

1Put the mains plug in the wall socket.

•• 00:00 flashes on the display to indicate that you have to set the clock time.

2Turn the knob to set the hour (Fig. 2).

3Press in the centre of the knob to confirm the hour (Fig. 3).

•• The minutes start to flash to indicate that you have to set the minutes.

4Turn the knob to set the minutes (Fig. 4).

5Press in the centre of the knob to confirm the minutes (Fig. 5).

6The display shows the set clock time.The coffeemaker is ready for use.

4.2Setting the automatic switch off time

You can adjust the time after which the appliance automatically switches off.The default time is set to 30 minutes.You can adjust this time to a maximum of 120 minutes. If you want to adjust the automatic switch off time, follow the steps below.

1Make sure the appliance is switched off (but the mains plug is in the wall socket).

2Press and hold in the centre of the knob until the display starts to flash.

3Turn the knob to increase or decrease the time. 1 is 10 minutes, 2 is 20 minutes, 3 is

30 minutes and so on until 12 is 120 minutes.

4Press in the centre of the knob to confirm the minutes.

D Note:

The appliance always saves the last setting.

4.3 Flushing the appliance

You need to flush the coffeemaker once before			SH
first use.			L I
		Open the water reservoir lid. Fill the water	E N G
	1
		reservoir with fresh cold water up to the
		8-cup indication.  (Fig. 6)
		D Note:
		Do not put coffee beans or ground coffee in
		the appliance.
		Close the water reservoir lid.
	2
		Put the jug in the appliance (Fig. 7).
	3
		Press the on/off button (Fig. 8).
	4
		•• The display lights up.
		Press the strength select button (Fig. 9).
	5
		Turn the knob to choose the pre-ground
	6
		coffee setting (Fig. 10).
		•• The pre-ground coffee icon lights up.
		Press in the centre of the knob to confirm.
	7
		Then press in the centre of the knob again to
		start the flushing process (Fig. 11).
		Let the appliance operate until the flushing
	8
		process has been completed.
		Empty the jug.
	9

5 Using the appliance

5.1 Filling the water reservoir

1Open the water reservoir lid and fill the water reservoir with the required amount of cold water.  (Fig. 6)

When you open the water reservoir lid, there are indications for 2 to 10 cups on the inside of the appliance.You can use these indications to determine how much water to put in the water reservoir.The reflection changes from light to dark per filled cup of water.You can also use the water level indicator on the jug.

D Note:

Do not fill the water reservoir beyond the 10-cup indication.

7