Repeat play a specific section
Select sections of audio for repeat playback.
1
2
»» Repeat play starts.
»» To cancel repeat
Note
•• Repeat play is only possible within a track.
Play from radio
1 Check that the FM antenna is connected.
2 Press RADIO.
»» “AUTO INSTALL...PRESS PLAY’ appears on the display panel if you have not installed any radio stations. Press 
.
3 Press the following buttons to control play:
Button | Action | ||
/ | Selects a preset radio station. | ||
/ | Searches for a radio station. | ||
|
|
| Fine tunes a radio frequency. |
|
|
| Press and hold to erase the |
|
|
| |
|
|
| |
|
|
| preset radio station. |
PROGRAM | Manual: Press once to access | ||
|
|
| program mode, press / to |
|
|
| assign a number to the radio |
|
|
| station, then press again to store |
|
|
| the radio station. |
|
|
| Automatic: Press and hold for |
|
|
| three seconds to reinstall radio |
|
|
| stations. |
Note
•• The home theater can store up to 40 radio stations.
•• Press 
to stop the installation.
•• AM and digital radio are not supported.
•• If no stereo signal is detected, or if fewer than five stations are found, you are prompted to install the radio stations again.
•• For the best reception, place the antenna away from the TV or other sources of radiation.
Play from an MP3 player
Connect and play audio files from an MP3 player | l i s h | |
or other external audio devices. | En g | |
1 | Connect the MP3 player to the home |
|
2 | theater. |
|
Press MP3 LINK. |
| |
3 | »» ‘MP3 LINK’ appears on the display panel. |
|
Press the buttons on the MP3 player to |
| |
select and play audio files.
Use Philips EasyLink
The home theater supports Philips EasyLink, which uses the HDMI CEC (Consumer Electronics Control) protocol. EasyLink- compliant devices that are connected through HDMI connectors can be controlled by a single remote control.
Note
•• Philips does not guarantee 100% interoperability with all HDMI CEC devices.
1 Switch on the HDMI CEC operations on the TV and other connected devices. See the manual of the TV or other devices for details.
Press 
SETUP.
Select [General Setup], then press OK. Select [EasyLink Setup], then press OK. Select and adjust the following settings:
•[EasyLink] : Enables or disables EasyLink.
•[One Touch Play] : Enables or disables One Touch Play.
If enabled, you can use the remote control to start USB play in the home theater and the TV switches automatically to the correct channel.
•[One Touch Standby] : Enables or disables One Touch Standby.
If enabled, the home theater can be switched off to standby by a remote control from the TV or other connected HDMI CEC devices.
EN 11
