Warning
•• Check the battery polarity when inserting in the battery compartment. Incorrect polarity may damage the product.
Set the date and time
Tip
•• To set the date and time later, press REDIAL/C to skip this setting.
1 Press MENU/OK.
2 Select [Phone setup] > [Date & time],
then press MENU/OK to confirm.
3 Press the numeric buttons to enter the date, then press MENU/OK to confirm.
»»The time setting menu is displayed on the handset.
4 Press the numeric buttons to enter the time.
• If the time is in 
/ 
to select [am] or [pm] (Country
dependent).
5 Press MENU/OK to confirm.
Change the remote access PIN code
Note
•• The default answering machine remote access PIN code is 0000 and it is important to change it to ensure the security.
1 Press MENU/OK.
2 Select [Answ. Machine] > [Remote
access] > [Change PIN], then press
MENU/OK to confirm.
3 Enter the old PIN/passcode, then press MENU/OK to confirm.
4 Enter the new PIN/passcode, then press MENU/OK to confirm.
5 Enter the new PIN/passcode again, then press MENU/OK to confirm.
»»The setting is saved.
Charge the handset
Charge your handset by docking it in either direction.When the handset is placed correctly on the base station, you hear a docking tone (see 'Set the docking tone' on page 18).The LED at the back of the handset flashes once.
»»The handset starts charging.
Note
•• Charge the batteries for 8 hours before first use.
•• If the handset becomes warm when the batteries are being charged, it is normal.
•• Over time, capacity of batteries decreases.This is a normal battery behavior.
Your phone is now ready to use.
Check the battery level
The battery icon displays the current battery level.
When the handset is off the base station, the bars indicate the battery level (full, medium and low).
8EN
