Preparations
C Speakers connection
Front Speakers
Connect the speaker wires to the SPEAKERS terminals, right speaker to "R" and left speaker to "L", colored (marked) wire to "+" and black (unmarked) wire to
1 | 2 |
●Fully insert the stripped portion of the speaker wire into the terminal as shown.
Notes:
–To avoid magnetic interference, do not position the front speakers too close to the PC monitor/TV.
–For optimal sound performance, use the supplied speakers.
–Do not connect more than one speaker to any one pair of +/- speaker terminals.
–Do not connect speakers with impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.
Home Network
gateway router
DSL or
cable modem
INTERNET
data port
1Connect your PC, gateway router and broadband modem (cable/DSL) according to the router’s setup instructions.
2Configure your gateway router following the directions specified in your router’s manual and make sure that the PC’s internet connection is installed properly and working. If you have problems with the setup of the internet connection, contact your networking equipment manufacturer.
Connecting Streamium MC-i200
1After the internet connection
has proven to be working, connect the system to the gateway router with the supplied cable.
IMPORTANT!
Do not connect the Streamium
gateway router
DSL or
cable modem
from RJ45
INTERNET
data port
2Press INTERNET. You will now be guided through the installation process of the system. Depending on your network setup, you might have to enter network configuration data. Please follow the instructions on the system’s display, using the navigation jog, the OK/PLAY (2) and the numerical/alphabetical keypad on the remote control to enter the requested connection information.
Notes:
–You will be asked to enter your
Follow the link displayed in the
–For later modification of the connection settings, press INTERNET and OPTIONS followed by the soft key (!) on the system to select “SET” options.
E n g l i s h
11
