Philips MC165 POWER SUPPLY, Supplied accessories, Safety information, Maintenance, Batteries for the remote control, Loudspeaker connections, Mains

GENERAL INFORMATION REMOTE CONTROL POWER SUPPLY

English

Supplied accessories

–2 loudspeaker boxes–2 loudspeaker cables–Remote control–2 batteries for the remote control–AM/MW frame antenna–FM wire antenna–Mains lead

AKER+
SPE–	R			M
			A			L
					RIA
			AE
R	L
		AC	MAINS
L
SUBWOOFER

Safety information

Place the set on a solid surface. Make sure that there is sufficient space around the set to prevent overheating.

Active mobile phones near to the CD-player may cause malfunctions.

Maintenance

Do not expose the set, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight).

You can clean the set with a soft, slightly dampened lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect.

Batteries for the remote control

•Open the battery compartment of the remote control and insert 2 batteries, type R03, UM-4or AAA-cells (preferably alkaline).

Remove batteries if they are flat or the set is not going to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

Loudspeaker connections

The loudspeaker terminals are click-fit connectors. Use them as shown below.

•Connect the unmarked wire to the red terminal and the marked (black) to the black one.

Mains

The type plate is located on the bottom of the set.

1Check whether the mains voltage as shown on the type plate corresponds to your local mains voltage. If it does not, consult your dealer or service organisation.

2Connect the mains cable to the AC MAINS inlet and the wall socket. This switches on the mains supply.

To disconnect the set from the mains completely, remove the mains plug from the wall socket.

For users in the U.K.: please follow the instructions on page 2.

This set complies with the radio interference requirements of the European Community

8 mm

1 2

To avoid overheating of the set a safety circuit has been built in. Therefore your set may disconnect under extreme conditions. If this happens, switch

3the set off and let it cool down before reusing it.

6