Philips MCD300/93 manual Basic Operations, Switching the system on/off, Volume control

Basic Operations

English

IMPORTANT!

–Before you operate the system, complete the connection procedures.

–When the system is switched to Standby mode, it is still consuming power.To disconnect the system from the power supply completely, reomve the AC power plug from the wall socket.

Switching the system on/off

●Press STANDBY ONB (B on the remote).

➜“HELLO” is displayed briefly.The system will switch to the last selected source.

●Press DISC, TUNER or AUX on the remote.

➜The system will switch to the selected source.

To switch the system to standby mode

●Press STANDBY ONB (B on the remote).

➜The display shows “BYE BYE” briefly, then

----:-- -- (if you haven’t set time) or the set time. (See Setting the clock” on page 66.)

Helpful hints:

–The interactive sound settings, last selected source and tuner presets will be retained in the player’s memory.

Volume control

Turn VOLUME (+/-)clockwise or anticlockwise (or press VOLUME +/- on the remote) to increase or decrease the volume level.

➜The display shows ”VOL” and a volume value from “1” to “30” (“MIN” or “MAX” is displayed when the volume level is adjusted to the lowest or highest).

To listen through the headphone

●Connect the headphone plug to the n socket at the top of the system.

➜ The speakers will be muted.

IMPORTANT!

–Adjust the volume to a moderate level before you plug in the headphones.

To switch off the volume temporarily

●Press MUTE on the remote.

➜ Playback will continue without sound and “MUTE” flashes.

●To activate sound reproduction, you can:

– press MUTE again;

– adjust the volume controls;

– change source.

50