Philips MX5800SA/22S manual Troubleshooting, Problem Solution

	Troubleshooting
Problem	Solution
The DVD player does not start playback.	– Insert a readable disc with the playback side
	facing down.
	– Check the disc type, colour system and region
	code.
	– Check for any scratches or smudges on the disc.
	– Press SYSTEM SETUP to turn off the setup menu
	screen.
	– Change the rating level.
	– Moisture has condensed inside the system.
	Remove the disc and leave the system turned on
	for about an hour.

E n g l i s h

Cannot activate some features, such as Angles, Subtitles, or multi-language Audio.

There is no sound from the centre and surround speakers.

–The features may not be available on the DVD.

–Changing the language for the sound or subtitle is prohibited on the DVD.

–Make sure the centre and surround speakers are connected correctly.

–Press SURROUND button to select a correct surround sound setting.

–Make sure the source you are playing is recorded or broadcast in surround sound (DTS, Dolby Digital, etc.).

Radio reception is poor.	– If the signal is too weak, adjust the antenna or
		connect an external antenna for better reception.
	– Increase the distance between the system and
		your TV or VCR.
	– Tune in to the correct frequency.
	– Place the antenna farther away from any
		equipment that may be causing the noise.
The remote control does not function	–	Select the source (DISC or TUNER, for example)
properly.		before pressing the function button (ÉÅ, S ,
		T).
	– Reduce the distance between the remote control
		and the system.
	– Replace the batteries with new ones.
	– Point the remote control directly toward the IR
		sensor.
	– Check that the batteries are loaded correctly.
The timer is not working.	– Set the clock correctly.
	– Press and hold CLOCK•TIMER to switch on the
		timer.
The display panel is dark.	–	Press DIM again.
Low hum or buzz sound.	– Place the DVD system as far away as possible
		from electrical devices that may be causing
		interference.

45