MUnplug this apparatus during lightning storms or when unused for long periods of time.
NRefer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
OBattery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage, or damage to the unit:
•Install all batteries correctly, + and - as marked on the unit.
•Do not mix batteries (old and new or carbon and alkaline, etc.).
•Remove batteries when the unit is not used for a long time.
PApparatus shall not be exposed to dripping or splashing.
QDo not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles).
RThis product may contain lead and mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.
Warning
• | Never remove the casing of this NP1100. | ish |
• Never lubricate any part of this NP1100. | ngl | |
• | Place this NP1100 on a flat, hard and stable surface. | E |
| ||
• Never place this NP1100 on other electrical |
| |
| equipment. |
|
• Only use this NP1100 indoors. Keep this NP1100 away | Important | |
| from water, moisture and | |
• Keep this NP1100 away from direct sunlight, naked |
| |
| flames or heat. |
|
|
|
|
Notice
Notice of compliance
Warning
•Changes or modifications made to this equipment not expressly approved by Philips may void the FCC authorization to operate this equipment.
For USA:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
EN
