Philips REM380 setup guide Quick Features Setup Guide, Component Setup, Code Verification

QUICK FEATURES SETUP GUIDE

This guide is provided here for your conve- nience as a quick reference for performing remote control sequences.

If you need more details, reread the full instructions presented in earlier pages.

Component Setup

x 2

# # # # x 2

Turn on	Press component	Press SET	Enter 4-digit code	Press POWER
component	key once	until Red Light	for your brand;	once; if no
(e.g., TV).	(e.g., TV).	blinks twice;	Red Light blinks	response,
		release SET.	twice after last #.	repeat steps
				with next code.
1	2	3	4	5
Auto Scan
		x 2		x 2
Turn on	Press component	Press SET	Aim I-TV at	Press SET
component	key once	until Red Light	component; press	until Red Light
(e.g., TV).	(e.g., TV).	blinks twice;	SCAN once. When	blinks twice;
		release SET.	off, press any	release SET
* NOTE: Not VOL+, VOL-, EXIT, SCAN, or SET.			key* to stop.	to lock code.
1	2	3	4	5

Code Verification

x 2

		x 2
Press component	Press SET	Enter 9-9-0;	Press 1 once for 1st digit.
key once	until Red Light	the Red Light	Wait 3 sec. and count blinks.
(e.g., TV).	blinks twice;	will blink twice.	Number of blinks equals
	release SET.		value of code digit.
			Repeat with 2, 3, and 4.
1	2	3	4

Volume Lock

Press component* key once (e.g., CBL).

*NOTE: Component must have volume capabilities.

x 2
Press SET	Press VOL+ once.
until Red Light	Volume now controlled
blinks twice;	through component
release SET.	selected in step 1.

12 3

11