TROUBLESHOOTING
PROBLEM: Red Indicator Light does not blink when you press a key.
SOLUTION: Replace the batteries with four (4) new “AAA” alkaline batteries (see page 4).
PROBLEM: The VOL+,
SOLUTION: Make sure the remote control is not in the
PROBLEM: Red Indicator Light blinks when you press a key, but home entertainment compo- nent does not respond.
SOLUTION: Make sure you are aiming the
PROBLEM: The remote control does not control home entertainment components or commands are not working properly.
SOLUTION: Try all listed codes for the component brand being set up.Make sure all components can be operated with an infrared remote control.
PROBLEM: TV/VCR Combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for full oper- ation (see page 6).
PROBLEM: CH+,
SOLUTION: Due to an RCA design (1983- 1987), only the original remote control will operate these functions.
PROBLEM: Changing channels does not
work properly.
SOLUTION: If original remote control required pressing ENTER to change channels, press ENTER on the
PROBLEM: Tried Auto Scan and still could not find a working code.
SOLUTION: Try Auto Scan again after clearing out the component key as follows: Press and hold ENTER until Red Light blinks twice,then release. Next enter 9 - 9 - 2. Then press and release the component key to be cleared twice.
PROBLEM: Remote control does not turn on Sony or Sharp TV/VCR Combo.
SOLUTION: For power on, these products require programming TV codes into the
13
