PROGRAMMING YOUR REMOTE CONTROL
Philips/Magnavox Components
The DSS remote control can control up to six different components and is already
Programming Other Components
To control component brands other than Philips/Magnavox,you’ll need to perform the following steps to manually program the DSS with codes listed under Manufacturer’s Codes on pages 15 through 19. Or as alterna- tive, you can use the Auto Scan feature, on page 6, to program your component codes.
The following chart lists the remote control’s component keys and what type of device each key will control:
Key | Programmed To Control |
TV | TV |
VCR | VCR, DVD or LD Player |
CBL | Cable Box |
AUD | Amplifier, Tuner, Misc.Audio, |
| or CD Player |
DSS | Digital Satellite System |
CD | CD Player,Amplifier, Tuner, or |
| Misc.Audio |
NOTE: If you want the component keys to control other types of devices, you’ll need to reassign the component keys. See page 7.
IMPORTANT: Please completely read and review the following steps before proceeding.We recommend highlighting the codes (starting on page 15) for the brands you wish to program or writing them down in the supplied chart.
Setup Codes For My Components
TV
VCR
CBL
DSS
CD
DVD
AUDIO
LD
OTHER
To Manually Program The Remote Control:
NOTE: To program a TV/VCR Combo, skip these instructions and follow the steps on the next page.
1.Manually turn on a component (e.g.,TV, VCR,etc.) and,if applic- able,insert media (e.g.,cassette).
2. | On the remote con- |
| trol, press a compo- |
| nent key once (e.g., |
| TV, VCR, CBL, AUD, DSS, or CD). |
3. | Press and hold SET (approx. |
| 5 seconds) until the red light |
| blinks twice, then release SET. |
4.Enter the first
5.
Aim the remote control at the component and press POWER once. It should turn off. If it does not respond, repeat steps 2 and 3, trying each code for your brand until you find one that works. If it still does not work, try using Auto Scan (on page 6) to program your component.
6.Repeat steps 1 through 5 for each component you want to program into the DSS remote control.
NOTES: Press each key within 10 seconds of the previous entry. Otherwise,the remote con- trol will exit the programming mode.
If you press SET at any time (except during step 3), the remote control will exit the pro- gramming mode without saving your entries. You will have to start with step 1 to begin pro- gramming again.
5
