PROGRAMMING YOUR REMOTE CONTROL (continued)
Programming A TV/VCR Combo
Perform the following instructions to have the DSS control a TV/VCR Combo. For Sharp and Sony models, also see page 14.
IMPORTANT: Please completely read and review these steps before proceeding. Highlight the code (on page 17) for the brand you wish to program or write it down in the supplied chart.
Setup Code For My Component
TV/VCR
1.Manually turn on the TV/VCR Combo; insert a video cassette.
2. 
On the remote control, press VCR once.
3. 
Press and hold SET until the red light blinks twice, then release SET.
4.Use the Setup Codes For TV/VCR Combos (on page 17) to find the brand name. Enter the first four- digit code for your component.If performed correctly, the red light will blink twice.
5.
Aim the remote control at the TV/VCR Combo. Press POWER once. It should turn off. If it does not respond, repeat steps
NOTE: If the TV/VCR Combo does not have a Power key, press PLAY on the DSS.
6.If you’ve located a TV/VCR code that works, but it has a separate TV code, you’ll also need to pro- gram it into the remote control to access volume control as follows:
a. 
Press TV once.The red light will blink twice.
b. 
Press and hold SET until the red light blinks twice, then release SET.
c.Enter the TV code for the TV/VCR Combo. If performed cor- rectly, the red light will blink twice.
6.(continued)
If there is no separate TV code listed, you will need to perform the following steps to access vol- ume control:
a. Press VCR once.
b. 
Press and hold SET until the red light blinks twice, then release SET.
c. Press VOL +.
Programming With Auto Scan
If your component does not respond to the remote control after trying all codes listed for your brand,or if your brand is not listed at all, try searching for your code using Auto Scan. For example,to search for a code for a TV:
1. 
On the remote control, press TV once.
2. 
Press and hold SET until the red light blinks twice,then releaseSET.
3. 
Aim the remote control at the TV and press SCAN.The red light will blink twice.
4.Continue aiming the remote con- trol at the TV (which may take up to 5 minutes) until it turns off. Immediately press any key except
VOL+, VOL–, EXIT, SCAN, or SET.
NOTES: In the search mode, the remote will send IR (infrared) codes from its library to the selected device, starting with the most popular code first.
If you have passed by the code that turns off the TV, press VOL– one or more times until the TV turns on again.
5. 
To lock in the code and exit Auto Scan, press and release SET the red light will blink twice.
6.To search for codes of other com- ponents, repeat steps 1 through 5, but substitute the appropriate key (e.g., VCR, CBL, AUD, DSS, or CD) for the (VCR, Cable, Audio, Satellite, or CD) component you are searching for.
6
