Installation
Settings
As the RF Extender ‘communicates’ with the Pronto Remote Control, you have to set the same Extender ID (identity) on both appliances. The settings depend on whether you have a single RF Extender or multiple RF Extenders.
Single RF Extender
When you use only one RF Extender, you can accept the default setting for the Extender ID (ID=0). Make sure your Pronto Remote Control is set to the same default setting (see the Pronto User Guide for more details).
Multiple RF Extenders
If you want to operate several of your devices independently, e.g. grouped on different locations, you will need multiple RF Extenders. When using several RF Extenders, it is important to assign a unique Extender ID to each RF Extender. 16 Extender IDs (from 0 to 9 and from A to F) can be assigned.
1 Choose an Extender ID for the RF Extender by turning the ID dial with a small screwdriver.
2 On the Pronto Remote Control, choose the same Extender ID for each device controlled by the RF Extender.
Refer to the Pronto User Guide for more information.
3Try to operate your devices with the Pronto Remote Control.
The red LED will blink when the RF Extender receives a correct command.
4Repeat this procedure for every RF Extender.
RF Interference
If your devices are not responding to commands or if the red LED on the IR blaster is blinking without sending commands, it might be possible that there is RF interference. This can be the case when other RF appliances are operated nearby, for instance at your neighbours.
When you notice RF interference, you have to choose another channel on your
RF Extender. 4 channels (CH from 0 to 3) can be assigned.
1Choose a channel for the RF Extender by turning the CH dial with a small screwdriver.
2On the Pronto Remote Control, choose the same channel for the devices controlled by the RF Extender.
Refer to the Pronto guide for more information.
3 Try to operate your devices with the Remote Control.
User Guide
6
