Philips RFX9400 manual Support, Troubleshooting, What Do the LEDs Indicate?

RFX9400 Starter’s Guide

-or-

• a mini-jack IR cable.

Insert one mini-jack connector of the mini-jack cable in the IR output of the Extender.

Insert the other mini-jack connector in the AV-component.

Adjusting the Power Level of the IR Outputs

At the back of the Extender, there are 4 dipswitches, one for each IR output. Use these dipswitches to configure the power level of the Dual IR emitters and the mini-jack cables.

For example, flip the dipswitch down to lower the power level when the Extender is connected to an external IR bus system.

Support

Troubleshooting

What Do the LEDs Indicate?

LEDs	Ethernet LED	WiFi LED	Busy LED
Colors
Green blinking	The Extender’s IP address is	The Extender’s IP address is	The Extender is busy processing
	being determined.	being determined.	a short code or macro from the
			Control Panel.
Green	The Extender is functioning	The Extender is functioning	The Extender is busy processing
	normally.	normally.	a long macro from the Control
			Panel.
Red/green blinking	–	–	The Extender is being
			configured.
Red	Refer to the topic ‘There is an	Refer to the topic	Refer to the topic ‘There are
	IP conflict’ on page 7.	‘The Extender cannot	duplicate Extender IDs’
		communicate with the	on page 8.
Red blinking	Refer to the topic ‘The IP address	wireless network’ on page 8.	The Extender is starting up.
	cannot be determined’ on		Wait until startup has finished.
	page 7.

There is an IP conflict

There is another AV-component in the network that is using the same fixed IP address as the Extender. Change the IP address of the Extender in the Configuration Tool.

If the problem persists, check the router settings.

The IP address cannot be determined

•When using the Extender: make sure that the Extender is connected to the router with a straight Ethernet cable.

7