Philips SBC RU 510/00U manual Automatically setting the remote control

XP SBC RU 510/00.3 05-02-2004 16:43 Pagina 7

Instructions for use

Automatically setting the remote control

If you cannot find the right code for your brand device,

the remote control can automatically search for the right code.

1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).

The RU510 emits the ‘switch off TV’ signal for all models of TV that are stored in the memory.

2 Then keep keys 1 and 3 on the RU510	ME	NU		K
pressed simultaneously for three seconds,				O
until the green LED flashes twice and then	1		2	3
remains lit.	4		5	6
	7		8	9
	SHIFT		0

3Press the Standby key of the RU510 briefly

English

–The RU510 now starts emitting all known ‘TV off ’ signals, one by one.

Each time a code is sent, the green LED lights up

4When your TV switches off (stand-by), you press the Standby key of the RU510 twice within 1 second, to confirm.

2x

–The RU510 has now found a code that works on your TV.

5 Check if you can operate all functions on your TV with the RU510.

•If this is not the case, you can redo the automatic setting. The RU510 will then search for a code that perhaps works better.

–After the RU510 has run through all the known codes,

the search will stop automatically and the green LED will stop flashing.

–Automatic programming of a TV takes a maximum of 5 minutes.

7