Philips SCD589 EN Preparing your baby monitor, Baby unit is now ready for battery operateduse

EN Preparing your baby monitor

+

+

+

+

3Put the battery compartment cover (A-12) back in place. Close the compartment by turning the cover (A-12) to the right (CLOSE B), using the palm of your hand.

Note:When the units are switched off, in case of battery operated use, the batteries will still discharge slowly.

➜The baby unit is now ready for battery operateduse!

Parent unit

1Open the battery compartment by sliding the cover (B-12) downwards.

2Insert the two 1.2V AAA size NiMH rechargeable batteries (supplied), noting the + and – configuration inside the battery compartment.

3Put the battery compartment cover (B-12) back in place. Close the compartment by sliding the cover (B-12) upward until it clicks in position.

4Connect the AC power adapter (B-14) of the charging base (B-15) to a wall outlet.

5Place the parent unit in the charging base (B-15).

>The POWER light (B-16) lights up red.

6Leave the parent unit in the charging base until the batteries are fully charged (at least 16 hours).

>The POWER light (B-16) will stay red, even when batteries are fully charged.

>When the batteries are fully charged, the parent unit can be taken out of the charging base and used cordlessly for at least 8 hours.

>When the battery indicator ( ) in the display (B-8) is empty and the parent unit beeps, battery power is low. Place the parent unit in the charging base (B-16) to recharge the batteries.

10