English 11
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the answer to your question, contact the Customer Care Centre in your country.
QuestionAnswer
Why does the indicator LED not Check whether you have inserted the plug into a wall socket
burn?properly.
Perhaps you try to run the appliance at the wrong voltage. This appliance operates at mains voltages between 220 and 240 volts
Why does the indicator LED blink red while the appliance beeps?
Press the control knob to interrupt the process and check the water level in the base. Refill the base if necessary.
Why does the base overflow?
Why is the temperature of the milk too low after heating up?
You have poured too much water into the base. Stick to the quantities mentioned in the temperature overview.
You have selected a too low setting for the quantity of milk you want to warm. Switch on the appliance briefly again to warm the milk to the required temperature. Select a higher setting next time.
Why is the temperature of the milk too high after heating up?
Why are the contents of the jar not warm enough after heating up
Why are vegetables/fruit still not steamed properly after steaming?
Why does the food not defrost properly?
Why are there white spots in the bowl, the container and/or the steaming bowl?
You have selected a too high setting for the quantity of milk you want to warm or you left the bottle in the appliance too long. Select a lower setting next time and/or remove the bottle immediately after the process has ended.
Make sure the control knob has been set to n.
Stir the contents of the jar after heating up.
Perhaps you tried to heat a jar that contains more than 150g baby food.
You may have put too much in the steaming bowl. Decrease the quantity of vegetables or fruit.
You may have selected a too short steaming time. Switch on the appliance again to complete the steaming process.
Decrease the amount of food in the steaming bowl or select a longer steaming time.
These white spots are scale.To remove them, follow the instructions in chapter ‘Descaling’.
