3On the handset, press m, scroll n
to Advanced Set and press o Select.
4Scroll n to Register and press o Select.
5Enter the PIN when prompted and press o OK to confirm.
Registering… is displayed on the screen.
•Upon successful registration, a validation tone is emitted and the handset number (1 to 8) is assigned by the base station automatically.
6.2Checking the signal strength When you power on the registered handset, the display will show the word “Searching” and the Antenna icon flashes until the handset locks onto its subscribed base. Then the display shows the standby display.
7 Using the Handset
7.1Make a call
7.1.1 Predialing
When using the handset with the SE650/ 655/658 base station:
1Enter the number (maximum 24 digits) and then press t or l.
When using the handset with the dual- line SE659 base station:
1Enter the number (maximum 24 digits) and then press t. The
default line is highlighted. If you
want to switch to the other line, scroll n. Press t or o Select (or press l in speaker mode) to
start the call on the highlighted line.
7.1.2 Direct dialing
1Press t or l and then dial the number.
When using the handset with the
will go out on the default line. (To call from a particular line, press o Line 1 or c Line 2 before
dialing.)
7.2Answer a call
1When using the handset with the
SE650/655/658 base station, press t or l when the phone rings.
When using the handset with the
answer, press the appropriate soft key (o Line 1 or c Line 2).
7.3End a call
To end a conversation, press h.
18 | Using the Handset |
