EN
Flags | Indicates the route status: |
|
| C = Direct connection on the same subnet. |
|
| S = Static route. |
|
| R = RIP (Routing Information Protocol) assigned route. | |
| I = ICMP (Internet Control Message Protocol) Redirect route. | |
Flooding cracker block time. | Default 300 sec: Length of time from detecting a flood attack to blocking the attack. | |
Fragmentation | Default 10 sec: Configures the number of seconds that a packet state structure | |
| remains active. When timeout value expires, the router drops the | |
| unassembled packet, freeing that structure for use by another packet. | |
Gateway | Displays system IP settings, as well as DHCP Server and Firewall status. | |
Gateway | The IP address of the router at the next hop to which frames are forwarded. | |
Gateway | Enter the WAN IP address of the gateway to the remote network. | |
Group Key | The period of renewing broadcast/multicast key. | |
Default 10000 msec: Length of time before a | ||
sensitive time period. | is detected as |
|
Home networking | Sets the TCP/IP configuration for the ADSL Wireless Base Station LAN interface and | |
| DHCP clients. |
|
Incomplete TCP/UDP sessions | Default 250 sessions: Maximum number of allowed incomplete TCP/UDP sessions | |
(per min) HIGH | per minute. |
|
Incomplete TCP/UDP sessions | Default 200 session: Minimum number of allowed incomplete TCP/UDP sessions | |
(per min) LOW | per minute. |
|
Information | Displays the number of attached clients, the firmware versions, the physical MAC | |
| address for each media interface, and for the ADSL Wireless Base Station, as well as | |
| the hardware version and serial number. |
|
Interface | The WAN interface to be configured. |
|
Incomplete TCP/UDP sessions detect | Default 300 msec: Length of time before an incomplete TCP/UDP session is detected | |
as incomplete. | sensitive time period. |
|
Interleaved Path CRC Error | The number of Interleaved Path Cyclic Redundancy Check errors. | |
Interleaved Path HEC Error | Interleaved Path Header Error Concealment errors. | |
IP Address | The IP address of the ADSL Wireless Base Station. | |
IP Subnet Mask | The subnet mask of the network. |
|
IP Address | Traps are sent to this address when errors or specific events occur on the network. | |
Internet | Displays WAN connection type and status. Click the Connect button to connect to | |
| your ISP. |
|
Interface | The local interface through which the next hop of this route is reached. | |
Key Entry Method | Select Hex or ASCII code for encryption | key generation. |
Key Provisioning | Select Static if there is only one fixed key for encryption. | |
| If you want to select Dynamic, you would need to enable 802.1x function first. | |
Lease Time | Set the IP lease time. For home networks this may be set to Forever, which means | |
| there is no time limit on the IP address lease. |
|
Loss of Signal Defect | Momentary signal discontinuities. |
|
Maintenance | Contains options to backup & restore the current configuration, restore all | |
| configuration settings to the factory defaults, update system firmware, or reset the | |
| systems. |
|
Maximum | Default 30: Maximum number of | |
packet number from same host | host. |
|
39