Philips SNA6500 Statistics, Are also used for special functions, Number of cells transmitted

EN

Statistics	(Superframes represent the highest level of data presentation. Each superframe
	contains regular ADSL frames, one of which is used to provide superframe
	synchronization, identifying the start of a superframe. Some of the remaining frames
	are also used for special functions.)
	• Received cells	Number of cells received.
	• Transmitted cells	Number of cells transmitted.
Start IP Address	Specify the start IP address of the DHCP pool. Do not include the gateway address
	of the ADSL Wireless Base Station in the client address pool. If you change the pool
	range, make sure the first three octets match the gateway's IP address, i.e.,
	192.168.2.xxx.
Status	• Line Status	Shows the current status of the ADSL line connection.
	• Link Type	Two types of link: Fast path and Interleaved path.
Status	Provides WAN connection type and status, firmware and hardware version numbers,
	system IP settings, as well as DHCP, NAT, and firewall information. Displays the
	number of attached clients, the firmware versions, the physical MAC address for each
	media interface, and the hardware version and serial number. Shows the security and
	DHCP client log.
Subnet Mask	Enter the subnet mask of the remote network for which to set a static route.
System	Sets the local time zone, the password for administrator access, and the IP address of
	a PC or notebook that will be allowed to manage the ADSL Wireless Base Station
	remotely.
TCP SYN wait	Default 30 sec:Defines how long the software will wait for a TCP session to
	synchronize before dropping the session.
TCP FIN wait	Default 5 sec: Specifies how long a TCP session will be maintained after the firewall
	detects a FIN packet.
TCP connection idle timeout	Default 3600 sec (1 hour): The length of time for which a TCP session will be
		managed if there is no activity.
Total incomplete TCP/UDP sessions	Default 300 sessions: Defines the rate of new unestablished sessions sessions that will
HIGH	cause software to start deleting half-open sessions.
Total incomplete TCP/UDP sessions	Default 250 sessions: Defines the rate of new unestablished sessions that will cause
LOW	the software to stop deleting halfopen sessions.
UDP session idle timeout	Default 30 sec:The length of time for which a UDP session will be managed if there is
	no activity.
Valid	Enables/disables the entry.
Version	Sets the RIP (Routing Information Protocol) version to use on this interface.
Version	Sets the trap status to disabled, or enabled with V1 or V2c.
	The v2c protocol was proposed in late 1995 and includes enhancements to v1 that
	are universally accepted. These include a get-bulk command to reduce network
	management traffic when retrieving a sequence of MIB variables, and a more
	elaborate set of error codes for improved reporting to a Network Management
	Station.
VPI/VCI	Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI).
WAN	Specifies the Internet connection settings.
WEP Mode	Select 64 bit or 128 bit key to use for encryption.
Wireless	Configures the radio frequency, SSID, and security for wireless communications.
Wireless Mode	This device supports both 11g and 11b wireless networks.
	Make your selection depending on the type of wireless network that you have.
Quiet Period	Defines a maximum period of time for which the ADSL Wireless Base Station will
	wait between failed authentications.
802.1X Authentication	Enable or disable this authentication function.

41