Philips manual 26 SRM7500 Instructions for Use, Enjoying Your SRM7500, Wizard, No Connection

26SRM7500 - Instructions for Use

Problem Cause Solution

I want to quit the installation

wizard.

To quit the installation wizard you

press or once.

■When you did not yet install a connection to the PC, the remote will restart the wizard on your SRM7500.

■When you installed the connection to the PC already, the remote will turn into the music controller.To install a device, you need to add each device individually like described in chapter ‘Add a Device’ on page 16.

Enjoying Your SRM7500

Problem		Cause
The No Connection		The SRM7500 is too
icon	blinks in	far from the PC to
		set up a connection.
the upper right-hand

corner of the screen.

Solution

The SRM7500 should be maximum 33 ft (10 m) from the PC. Obstructions in the path from the remote to the PC can reduce this distance.

The PC is not	Turn on your PC.
powered.

The PC is in standby mode.

It can take a while for the PC to start up after standby mode. During start-up, you will see the No Connection icon blinking on the remote.

The MediaControl software is disabled.

Check the icon in the taskbar.

When the icon is blue, the software is disabled.

To enable the software, right-click the icon in the taskbar and select Enable.The icon will turn

green .

© 2007 - Philips Innovative Applications, Interleuvenlaan 74-76, 3001 Leuven (Belgium) SRM7500 - Instructions for Use