Philips TH-42PH10EK operating instructions Connections, Speakers, AC cord fixing

Unplug the AC cord pressing the two knobs.

Connections

When connecting the speakers, be sure to use only the optional accessory speakers. Refer to the speaker’s Installation Manual for details on speaker installation. (Example: TH-42PH10EK)

Speakers (Optional accessories)

SPEAKERS

Terminals (L)

SPEAKERS	AC cord connection
Terminals (R)
	(see page 12)
	– AC cord fixing

1
2	1
	2

Plug the AC cord into the display unit. Plug the AC cord until it clicks.

Note:

Make sure that the AC cord is locked on both the left and right sides.

Unplug the AC cord

Note:

When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.

– Cable fixing bands Secure any excess cables with bands as required.

Pass the attached cable fixing band through the clip as shown in the figure.

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

To tighten: To loosen:

Push the catch

						Pull
1					2				Pull
R AUDIO	L	S VIDEO R	AUDIO	L	VIDEO				AUDIO
	B	AV IN		A
		SLOT1			SLOT2	SLOT3	PC	IN	SERIAL

Dual Video Terminals (equivalent of BNC Dual Video Terminal Board (TY-FB9BD)) (see page 11)

Optional Terminal Board Insert Slot (covered)

From EXTERNAL monitor terminal on Computer (see page 9)

From SERIAL Terminal on Computer

(see page 10)

Notes:

•On TH-42PH10EK/S, TH-50PH10EK/S and TH-58PH10EK, Terminal board is installed in SLOT 1 at factory shipment.

•On TH-42PS10EK/S, SLOT 1-3 are all empty at factory shipment.

8