![](/images/new-backgrounds/1217702/21770267x1.webp)
SHOWVIEW |
|
|
SHOWVIEW NUMBER | REP. |
|
èONCE | p |
________________________________
REP.pSELECT STOREpOK TIMER LISTpTIMER
3Enter the entire ShowView number. This number is up to 9 digits long and can be found next to the start time of the TV programme in your TV listings magazine.
e.g.
Enter 53124 for the
If you make a mistake, you can clear your instructions with CLEAR (CL) .
Selecting onetime/daily/weekly recordings
Using SELECT , select from the following options: 'ONCE': Recording once
'WEEK.': Repeated weekly recordings (every week on the same day)
TIMER
VPS
DATE REP. PROG. START PDC END
21
________________________________
REP.pSELECT STOREpOK
4Confirm with OK .
aThe following message appears on the screen: 'SELECT PROG.
NR.'
b The programme number of the TV channel has not yet been assigned to the ShowView number. Using the number buttons
aThe following message appears on the screen: 'SHOWVIEW NUMBER
NOT VALID'
b The entered ShowView number is incorrect. Correct your instructions or end with MENU .
b Check the time/date (see chapter 'Installing your video', section 'Setting the time and date').
aThe following message appears on the screen:
b A daily recording was entered for the wrong day. Daily programming can only be used for recordings to be made from Monday to Friday.
5The decoded data appears after confirmation. You can go back to change the data. Select the corresponding input field using SqP or QSr . Change the data with P ;q , P =r or with the number buttons
Switching on 'VPS/PDC' in the 'START' input field
Select the 'START' input field using SqP . Using SELECT switch on 'VPS/PDC' (']' lights up). If you press SELECT again, you will switch 'VPS/PDC' off (']' goes out).
6When all informations are correctly, confirm with OK . The programming information is stored in a TIMER block.
7 Insert a cassette with an intact security tab (unprotected).
30 | Programming a recording (TIMER) |
|