Section
03
Connecting the System 
Connecting the power cord (2)
Speed detection circuit lead
Vehicle injection
computerConnector
3 m (9 ft. 10 in.)
Pink (CAR SPEED SIGNAL INPUT)
This connection is unnecessary for
The mobile navigation system is connected here to detect the distance the vehicle travels. Always connect the vehicle´s speed detection circuit. Failure to make this connection will increase errors in the location display.
Connection method
Pass the extension cord and the lead for the speed detection circuit through this hole.
Clamp firmly with needle- nosed pliers.
Close the cover.
WARNING
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELECTRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE VEHICLE´S ANTILOCK BRAKING SYSTEM, AUTOMATIC TRANSMISSION AND SPEEDOMETER INDICATION.
CAUTION
It is strongly suggested that the speed pulse wire be connected for accuracy of navigation and better performance.
Note
The position of the speed detection circuit and the position of the parking brake switch vary depending on the vehicle model. For details, consult your authorised Pioneer dealer or an installation professional.
WARNING
Light green
Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch.
If this connection is made incorrectly or omitted, certain functions of your navigation system will be unusable.
LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO DETECT PARKED STATUS AND MUST BE CONNECTED TO THE POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
Connection method
Clamp the parking brake switch power supply side lead.
Clamp firmly with
Power supply side
Ground side
Parking brake switch
12
En
