Pioneer BDR-203, BDC-203 manual Read Buffer Capacity Command, Read Capacity Command

BDR-203/BDC-203 Command Reference Manual Version 0.90

4.16 READ BUFFER CAPACITY Command

The Block bit is supported.

The Length of Buffer field in the READ BUFFER CAPACITY data is set to following.

BD or no medium : 180000h

DVD : 118000h

CD : 126800h

4.17 READ CAPACITY Command

The RelAdr bit is not supported and must set to 0.

If empty disc is mounted, the Logical Block Address field in the Read Capacity Data is set to zero.

If a non-blank +RW disc is mounted, the Logical Block Address field in the Read Capacity Data is set to 23053Fh.

If a disc that is not a +RW and has no Complete Session is mounted, Logical Block Address field in the Read Capacity Data is set to zero.

When a CD-R/RW disc is mounted, if it is recorded by Track-at-once, the Logical Block Address field in the Read Capacity Data is set to the LBA immediately behind of the outermost Lead-out, so 2 Run-out blocks will be encountered.

4.18 READ DISC INFORMATION Command

For +R/+R DL media, the Last Session Lead-in Start Address is the LBA of where the next I tro shall be recoded. If no session exists on the disc, then the value returned is 00000000h. If the disc has complete status, then the value re ur ed s FFFFFFFFh.

For +R media, the Last Possible Lead-out Start Address is the LBA found in the ADIP of the disc’s lead-in. If the disc has complete status, then the value returned is FFFFFFFFh.

For +R DL media, the Last Possible Lead-out Start Address is set as follows.

1) In case of a disc that has no complete status, it is set to the following value.

The value = ( L0 Data Zone Capacity + 1 – 30000h ) x 2 – Exte ded Part al Lead-out Size

As for the L0 Data Zone Capacity,

if it has not been changed from the default value, it is set to the Last Possible Physical Sector of the Data Zone on Layer 0 in ADIP,

and if it has been changed from the default value, it is set to the Actual last PSN of Data Zone on Layer 0 in TOC.

As for the Extended Partial Lead-out Size,	ONFIDENTIAL
C
if the disc has an Ext nd d Pa tial Lead-out, it is 30000h,
and if the disc has no Ext nd d Pa tial Lead-out, it is 0.
IONEER

2) In case of a disc that has a complete status, it is set to FFFFFFFFh. The OPC table is ot support d for +R/+RW/+R DL media.

P

Page 36