TROUBLESHOOTING
Symptom | Cause |
POOR SOUND | QUALITY |
Unstable | or interrupted | • | The head, pinch | rollers | and capstans | are dirty. | ||
sound |
| • | The tape is not uniformly | wound. |
|
| ||
No high | frequencies |
| A tape | recorded | without | Dolby NR | is being | |
|
|
| played | back with | DOLBY | NR switch | in | the B/C or |
Sposition.
The head is dirty.
Remedy
• Clean | (see | page 4). |
| |
• | Completely | or rewind the tape. | ||
• | Set DOLBY | NR ON/OFF | switch to OFF. | |
• | Clean | the head (see page 4). |
High frequencies are emphasized.
Sound from previous recordings remains when rerecording a tape.
The sound is distorted.
Too much noise
OTHERS
A Dolby
position.
The head is dirty.
Recording level is too high.
The recorded signal itself is distorted. The head is dirty.
Hi noise tape is being used.
Incomplete insertion of a connection cord, poor contact.
Recording level is too low.
The head is dirty.
The head is magnetized.
• Set the DOLBY NR ON/OFF switch to ON first, | |
then set the DOLBY NR switch to the same | |
position | used for recording. |
• Clean the head (see page 4). | |
Turn REC LEVEL control down when recording | |
(see page 14). | |
Replace | the cassette. |
Clean the head (see page 4), | |
Replace | the cassette. |
Check connections (see page 6). | |
Turn REC LEVEL control up when recording (see | |
page 14). | |
Clean the head (see page 4). | |
Demagnetize with a head demagnetizer. |
The music search function | • | Blanks between selections are less than 4 | |||
does not work. |
|
| seconds long. | ||
Cannot use the remote | • | The control cord is not connected. | |||
control system | (Except for |
|
| ||
|
|
| |||
CDeDECK SYNCHRO is | • | The components are not connected properly. | |||
disabled. |
|
| • | The cassette erasure prevention tabs are broken. | |
The | CD SYNC | indicator is |
| The tape ran out during the CDeDECK SYNCHRO | |
off | during | CDeDECK |
| mode. | |
SYNCHRO | recording, |
| After the deck entered recording standby mode, | ||
|
|
|
|
| more than 1 minute elapsed before the CD player |
|
|
|
|
| resumed playback. |
• | Use a tape with blanks more than 4 seconds | |
| long. |
|
• | Connect | the control cord (see page 6). |
• | Connect | them properly (see page 6). |
• | Replace | the cassette with one whose tabs are |
| intact. |
|
| Replace | the tape with a longer one. |
| Change the disc and press the CD SYNC button | |
| again. |
|
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause fire or give you an electrical shock. Check the power cord once ina while. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement.
2O
<RRB1143>
En