FHEADPHONES MIXING control
Adjusts the balance of the monitor volume between the sound of the channels for which the headphones [CUE] button is pressed and the sound of the master channel.
GMASTER CUE button
Turns monitoring of the master output’s sound on and off.
HSAMPLER VOLUME fader
Adjusts the sampler’s overall sound level.
Effect section
This section is used to control the two effect units (FX1 and FX2). Controls and buttons to operate the FX1 unit are located on the left side of the controller, those to operate the FX2 unit are located on the right side of the controller. The channels to which the effect is to be applied are set using the effect assign buttons .
1 1 1 2
3 3 3 4
1Effect parameter controls
These adjust the effects’ parameters.
2FX BEATS control
Adjusts the effect time.
3Effect parameter buttons
Press:
Turns the effect on and off or switches the parameter.
[SHIFT] + press: Switches the effect type.
4TAP button
Press:
The BPM used as the base value for the effect is calculated by the interval at which the button is tapped with a finger.
When the button is pressed and held, the effect time is reset.
[SHIFT] + press: Switches the effect mode.
!This function (Effect Mode Switching) cannot be used with Serato DJ Ver. 1.0. It is scheduled to be supported in a future version update.
To monitor the effect sounds
When the [HEADPHONES MIXING] control is turned to the [CUE] side, the Serato DJ software’s effect sounds are not output in the sound of channels whose headphones [CUE] button is pressed. To monitor the Serato DJ software’s effect sounds, turn the [HEADPHONES MIXING] control to the [MASTER] side, turn on the [MASTER CUE] button and monitor the effect sound with the master output’s sound.
names part and Connections
En 15