Connections and part names

Connections

!Wait until all connections between devices have been completed before connecting the AC adapter.

Be sure to turn off the power and unplug the AC adapter from the power outlet before making or changing connections between devices.

Refer to the operating instructions for the component to be connected.

!Only use the AC adapter included with this unit.

!Power is supplied to this unit by the AC adapter.

!Connect this unit and the computer directly using the included USB cable.

!A USB hub cannot be used.

!Refer to the operating instructions for the component to be connected.

names part and Connections

Names of Parts

Rear panel

1

2

3

4

5

6

1MASTER OUT 1 terminals

Connect powered speakers, etc., here.

!Compatible with XLR connector type balanced outputs.

2MASTER OUT 2 terminals

Connect to a power amplifier, etc.

!Compatible with RCA pin-jack type unbalanced outputs.

3BOOTH terminals

Output terminals for a booth monitor, compatible with balanced or unbalanced output for a TRS connector.

The master channel sound can be output from the [BOOTH] terminals regardless of the audio level set for the master channel.

!The sound will be distorted if the level is raised too high when using unbalanced outputs.

4MIC2 terminal

Connects a microphone here.

!The [INPUT SELECT] switch on the main unit’s front panel must be set to [MIC2].

5CD terminals

Connect to a DJ player or other line level device.

!The [INPUT SELECT] switch on the main unit’s front panel must be set to [CD].

6PHONO/LINE input terminals

Connect a phono level output device (analog player (for MM car- tridges), etc.) or a line level output device (DJ player, etc.) here. Switch the terminals’ function according to the connected device using the [INPUT SELECT] switch on this unit’s front panel.

7SIGNAL GND terminal

Connects an analog player’s ground wire here. This helps reduce noise when the analog player is connected.

7 6 5 8 9 a b c d

8MIC1 jack

Connects a microphone here.

!The [INPUT SELECT] switch on the main unit’s front panel must be set to [MIC1].

!Either an XLR connector or a phones plug (Ø 6.3 mm) can be used.

9Kensington security slot

A USB terminal

Connect to a computer.

!Connect this unit and the computer directly using the included USB cable.

!A USB hub cannot be used.

BSTANDBY/ON switch

This switches this unit’s power between on and standby.

CDC IN terminal

Connect to a power outlet using the included AC adapter (with the power plug mounted).

!Wait until connection of all equipment is completed before con- necting the AC adapter.

!Only use the included AC adapter.

DCord hook

Catch the AC adapter’s power cord and USB cable on this hook when using this unit.

!The sound will be interrupted if the AC adapter or USB cable is disconnected during playback.

En 9