Section

01Operating this unit

 

Section

Operating this unit

01

Selecting a source

1Press S (SRC/OFF) to cycle between:

TUNER (tuner)—CD (built-in CD player)—USB (USB)—AUX (AUX)

Adjusting the volume

1Turn M.C. to adjust the volume.

CAUTION

For safety reasons, park your vehicle when removing the front panel.

Note

When this unit’s blue/white lead is connected to the vehicle’s auto-antenna relay control terminal, the vehicle’s antenna extends when this unit’s source is turned on. To retract the antenna, turn the source off.

CAUTION

!Use one CR2025 (3 V) lithium battery.

!Remove the battery if the remote control is not used for a month or longer.

!There is a danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.

!Do not handle the battery with metallic tools.

!Do not store the battery with metallic objects.

!If the battery leaks, wipe the remote control completely clean and install a new battery.

!When disposing of used batteries, comply with governmental regulations or environmen- tal public institutions’ rules that apply in your country/area.

!“Perchlorate Material – special handling may apply.

See www.dtsc.ca.gov/hazardouswaste/ perchlorate. (Applicable to California, U.S.A.)”

Returning to the ordinary display

Canceling the initial setting menu

1Press B (BAND/ESC).

Returning to the ordinary display from the list

1Press B (BAND/ESC).

Tuner

Basic Operations

Selecting a band

1Press B (BAND/ESC) until the desired band (F1, F2, F3 for FM or AM) is displayed.

Manual tuning (step by step)

1Press c or d.

Seeking

1 Press and hold c or d, and then release.

You can cancel seek tuning by briefly pressing c

display.

English

Note

 

Depending on the area, you cannot switch the

 

Function settings

1Press M.C. to display the main menu.

2Turn M.C. to change the menu option and press to select FUNCTION.

3Turn M.C. to select the function.

After selecting, perform the following procedures to set the function.

BSM (best stations memory)

BSM (best stations memory) automatically stores the six strongest stations in the order of their signal strength.

1 Press M.C. to turn BSM on.

To cancel, press M.C. again.

Use and care of the remote control

Using the remote control

1Point the remote control in the direction of the front panel to operate.

When using for the first time, pull out the film protruding from the tray.

Replacing the battery

1Slide the tray out on the back of the remote con- trol.

2Insert the battery with the plus (+) and minus (–) poles aligned properly.

WARNING

!Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor immediately.

!Batteries (battery pack or batteries installed) must not be exposed to excessive heat such as sunshine, fire or the like.

6 En

Important

!Do not store the remote control in high tem- peratures or direct sunlight.

!The remote control may not function properly in direct sunlight.

!Do not let the remote control fall onto the

floor, where it may become jammed under the brake or accelerator pedal.

Menu operations identical for function settings/audio adjustments/initial settings/lists

Returning to the previous display

Returning to the previous list (the folder one level higher)

1Press .

Returning to the main menu

Returning to the top tier of list

1Press and hold .

or d.

While pressing and holding c or d, you can skip

stations. Seek tuning starts as soon as you re-

lease c or d.

Storing and recalling stations for each band

Using preset tuning buttons

1When you find a station that you want to store in memory, press one of the preset tuning buttons (1 to 6) and hold until the preset number stops flashing.

2Press one of the preset tuning buttons

(1 to 6) to select the desired station.

# You can also recall stored radio stations by pressing a or b during the frequency display.

Switching the display

Selecting the desired text information

1Press .

Program service name—song title—artist name

Scrolling the text information to the left

1Press and hold .

LOCAL (local seek tuning)

Local seek tuning lets you tune in to only those radio stations with sufficiently strong signals for good re- ception.

1Press M.C. to display the setting mode.

2Turn M.C. to select the desired setting.

FM: OFF—LEVEL 1—LEVEL 2—LEVEL 3—LEVEL 4

AM: OFF—LEVEL 1—LEVEL 2

The highest level setting allows reception of only the strongest stations, while lower levels allow the reception of weaker stations.

3Press M.C. to confirm the selection.

CD/CD-R/CD-RW and USB storage devices

Basic Operations

Playing a CD/CD-R/CD-RW

1Insert the disc into the disc loading slot with the label side up.

Ejecting a CD/CD-R/CD-RW

1Press h.

En 7