Section

02 Installation

 

Section

Installation

02

2Power amp (sold separately)

3Connect with RCA cable (sold separately)

4To Rear output or subwoofer output

5Rear speaker or subwoofer

Installation

Important

!Check all connections and systems before final installation.

!Do not use unauthorized parts as this may cause malfunctions.

!Consult your dealer if installation requires dril- ling of holes or other modifications to the vehi- cle.

!Do not install this unit where:

—it may interfere with operation of the vehi- cle.

—it may cause injury to a passenger as a re- sult of a sudden stop.

!The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.

!Optimum performance is obtained when the unit is installed at an angle of less than 60°.

60°

DIN front/rear mount

This unit can be properly installed using either front-mount or rear-mount installation.

Use commercially available parts when instal- ling.

DIN Front-mount

1Insert the mounting sleeve into the dashboard.

For installation in shallow spaces, use the sup- plied mounting sleeve. If there is enough space, use the mounting sleeve that came with the vehicle.

2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place.

1

2

1Dashboard

2Mounting sleeve

3Install the unit as illustrated. 1

2

3

4

5

1Nut

2Firewall or metal support

3Metal strap

4Screw

5Screw (M4 × 8)

#Make sure that the unit is installed securely in place. An unstable installation may cause skip- ping or other malfunctions.

DIN Rear-mount

1Determine the appropriate position where the holes on the bracket and the side of the unit match.

2Tighten two screws on each side.

1 3

2

1Screw

2Mounting bracket

3Dashboard or console

!Use either truss (5 mm × 8 mm) or flush surface (5 mm × 9 mm) screws, depending on the bracket screw holes.

Removing the unit

1 Remove the trim ring.

1Trim ring

2Notched tab

!Releasing the front panel allows easier ac- cess to the trim ring.

!When reattaching the trim ring, point the side with the notched tab down.

2Insert the supplied extraction keys into both sides of the unit until they click into place.

3Pull the unit out of the dashboard.

Removing and re-attaching the front panel

You can remove the front panel to protect your unit from theft.

Press the detach button and push the front panel upward and pull it toward you.

For details, refer to Removing the front panel to protect your unit from theft and Re-attaching the front panel on page 5.

Securing the front panel

The front panel can be secured with the supplied screw.

1

1Screw

English

14 En

En 15