Pioneer DEH-600BT Initial Settings, Setting the FM tuning step, Switching Auto PI Seek

	Section
Initial Settings	04

3Press MULTI-CONTROL to turn the off

clock display on.

# To turn the off clock display off, press MULTI-CONTROL again.

Setting the FM tuning step

Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on, the tuning step automatically changes to 100 kHz. It may be preferable to set the tuning step to 50 kHz when AF is on.

1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.

2Use MULTI-CONTROL to select FM STEP.

3Press MULTI-CONTROL to select the FM tuning step.

Pressing MULTI-CONTROL repeatedly will switch the FM tuning step between 50 kHz and 100 kHz. The selected FM tuning step will appear in the display.

Note

The tuning step remains at 50 kHz during manual tuning.

Switching Auto PI Seek

The unit can automatically search for a differ- ent station with the same programming, even during preset recall.

1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.

2Use MULTI-CONTROL to select AUTO PI.

3Press MULTI-CONTROL to turn Auto PI

seek on.

# To turn Auto PI seek off, press MULTI-CONTROL again.

Switching the warning tone

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone.

1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.

2Use MULTI-CONTROL to select

WARNING.

3Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 45.

1Display the initial setting menu. Refer to Adjusting initial settings on the pre- vious page.

2Use MULTI-CONTROL to select AUX.

3Press MULTI-CONTROL to turn AUX on.

# To turn AUX off, press MULTI-CONTROL again.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (FULL) or subwoofer (SUB W) connection. If you switch the rear output set- ting to SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp.

Initial Settings

En 41