Pioneer DEH-600BT operation manual Using subwoofer output, Using the high pass filter

Section

03Audio Adjustments

4Push MULTI-CONTROL left or right to select a desired level.

Each time MULTI-CONTROL is pushed left or

right, level is selected in the following order: LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off.

Also, phase can be selected between normal and reverse.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 36.

2Use MULTI-CONTROL to select SUB W1.

3Press MULTI-CONTROL to turn subwoo- fer output on.

NORMAL appears in the display. Subwoofer

output is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

4Push MULTI-CONTROL left or right to select the phase of subwoofer output. Push MULTI-CONTROL left to select reverse phase and REV appears in the display. Push MULTI-CONTROL right to select normal phase and NORMAL appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

!When the subwoofer output is on, you can select SUB W2.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 36.

2 Use MULTI-CONTROL to select SUB W2.

3Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order:

50—63—80—100—125

4Push MULTI-CONTROL up or down to adjust the output level of the subwoofer. Each time MULTI-CONTROL is pushed up or down, subwoofer level increases or decreases.

+6 to –24 is displayed as the level is increased or decreased.

Using the high pass filter

When you do not want low sounds from the subwoofer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 36.

2Use MULTI-CONTROL to select HPF.

3Press MULTI-CONTROL to turn high pass filter on.

80HZ appears in the display. High pass filter is

now on.

# If the high pass filter has been previously ad- justed, the frequency of that previously selected

will be displayed instead of 80HZ.

# To turn high pass filter off, press MULTI-CONTROL again.

4Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the

following order:

50HZ—63HZ—80HZ—100HZ—125HZ

38 En