A HARDWARE TOUR

1

2

3 4 5

CD–R DRIVE

(when attached to changer)

1 SCSI ID switch

Used to specify the SCSI ID to be assigned to the DR-R102 drive. When the drive is to be used on the same SCSI bus as other devices (i.e., when the drive is to be daisy-chained to other devices), different IDs must be assigned to all devices on the same SCSI bus.

2 SCSI ports

3 SCSI termination switch

When components are connected through the SCSI connection, the terminator should be attached to the last component in the connection. In case this drive is the last component, set this switch to the on position.

4 Parity switch

When the parity switch is turned on odd parity checking is performed by the CD-R drive for all data read in from the SCSI data bus, and when the parity switch is turned off no parity checking is performed. Note that a parity bit is assigned to each byte of output data transmitted from the CD-R drive whether the parity switch is turned on or off.

5 Function switch label

Affix the label to the drive bay in which the CD-R drive has been inserted. (See No.6 of INSTALLING THE CD-R DRIVE on p. 9)

6

<DRC1128> En