INSTALLING THE CD-R DRIVE

Warning about static electricity

Always be sure never to touch the contacts or ports when operating drives.

Warning

÷Installing add-on drives is a task which requires advanced technical skills and knowledge, and to ensure safety always be sure to request that installation be performed by trained Pioneer service personnel. (For further information on how to request such service, please contact a retail dealer which handles the DR-R102 drive.)

÷Be sure to always link the drive positions, leaving no gaps between them. (i.e., first new add- on drive in drive bay #1, second new add-on drive in drive bay #2, etc.). Note that failing to do so may result in drives failing to operate properly.

Unused

DRIVE 3

DRIVE 2

DRIVE 1

(When three drives are installed)

1. Remove the rear plate covering the drive bay(s) in which new drive(s) is/ are to be installed, and then remove the rear panel of the changer.

(The example shown in the accompanying illustration shows the rear plates to be removed when installing three drives.)

2. Changer interface cable (left side) Remove the cable located in the drive bay where the drive is to be installed and take the cord clamper in hand.

÷ Do not remove cables in any other drive

Cord

bays.

holder

Power cable (right side)

Unlock all cord holder locks and pull the cable out towards you.

÷ If any drives have already been installed,

perform the above procedure only for Cord clamper those drive bays above the drive bays in

which drives have already been installed.

7

<DRC1128> En

English